065 75$16&(,9(5 ; $ ; $
Operator’s Manual • Use under Special Conditions
6076.0822.12.02 – 3.61 –
0HQX)52173$1(/$8',26285&(
By using the SELECT key one of the AF sources for the loudspeaker can be selected that have
been configured in Menu 575, e.g. CL1 or Guard U/V.
When CL1 is selected as AF source and communication mode V/D UNCP is active, the guard
receiver AF signal can be output at the loudspeaker in addition to the main receiver AF signal,
depending on the GUARD configuration (see Menu 110 (MANUAL FIX.FRQ), page 1 and
Menu 210, page 1 (USER PRESET FIX.FRQ)).
The following table shows how LEDs 1 and 2 are related and which AF signal is output by the
loudspeaker.
Starting point: Menu 400, page 2 (RADIO MAINTENANCE)
+ Press softkey (9) and the following display appears:
LED AF signal
12
no AF signal
OLJKWHG
AF signal of main receiver and in addition of guard receiver, if
switched on via softkey GUARD in Menu 110 (MANUAL
FIX.FRQ) or 210 (USER PRESET FIX.FRQ).
IODVKLQJ
AF signal of guard receiver (VHF band)
IODVKLQJ
AF signal of guard receiver (UHF band)
IODVKLQJ IODVKLQJ
AF signal of guard receiver (VHF and UHF bands)
LED 1 lighted
1. Press key LEDs 1 and 2 flashing
2. Press key none of the LEDs lighted
3. Press key LED 1 lighted
softkey AUDIO FRONTP...
+ Select audio source
To Next Page
Loading...
