Rohde & Schwarz XT 4410A - Page 243

065 75$16&(,9(5  ; $  ; $
Operator’s Manual • Technical Information
6076.0822.12.01 – A1.17 –
Starting point: Menu 040 (MAIN)
1. Press softkey
Menu 400 (RADIO MAINTENANCE)
2. ENTER maintenance PIN by using
the numerical keypad, then press
ENTER.
3. Press softkeys
Menu 510 (RADIO MODULES)
4. Press softkey
5. Select module VU POWER
AMPLIFIER by using the tunig knob.
6. Press softkey
Menu 516 (VU TX PARAMETERS)
7. Press softkey
8. Select UHF Power Amplifier VD 480L
by using the tuning knob, then press
ENTER.
9. Press softkey
10. Select UHF Power Amplifier VD 480L
by using the tuning knob, then press
ENTER.
11. Press softkey
12. Select power level LOW by using the
tuning knob, then press ENTER.
13. Press softkey
14. Enter a new power level, e.g. 1 W, by
using the numerical keypad, then
press ENTER.
15. Press softkey
16. Enter a new power level, e.g. 5 W, by
using the numerical keypad, then
press ENTER.
17. Press softkey to e.g.
deactivate the power level setting
(LOW).
18. Press softkey
19. Select power level MED by using the
tuning knob, then press ENTER.
20. Press softkey
21. Enter a new power level, e.g. 2 W, by
using the numerical keypad, then
press ENTER.
22. Press softkey
23. Enter a new power level, e.g. 10 W,
by using the numerical keypad, then
press ENTER.
24. Press softkey to e.g.
deactivate the power level setting
(MED).
25. Press softkey
26. Select power level HIGH by using the
tuning knob, then press ENTER.
27. Press softkey
28. Enter a new power level, e.g. 12 W,
by using the numerical keypad, then
press ENTER
29. Press softkey
30. Enter a new power level, e.g. 15 W,
by using the numerical keypad, then
press ENTER.
31. Press softkey to e.g.
activate the power level setting
(HIGH).