Rohde & Schwarz XT 4410A - Switching Transceiver On and Off

065 75$16&(,9(5  ; $  ; $
Operator’s Manual • Use under Normal Conditions
6076.0822.12.02 – 2.21 –
 6ZLWFKLQJWKH7UDQVFHLYHU2QDQG2II
 0657UDQVFHLYHU; $
2.5.2.1.1 Minimum Requirements
Before putting the M3SR Transceiver X. 4410A into operation make sure that the following min-
imum requirements are met:
• AC Power Supply IN 4000A (or a battery complying with the technical specifications) is
available.
• Antenna is connected.
• Handset or headset is connected.
• See also chapter 2.4 "Basic Cabling".
2.5.2.1.2 Switching On
1RWH
:KHQVWDUWLQJXSWKHWUDQVFHLYHUWKHODVWPHQXZKLFKZDVDFWLYHEHIRUHVZLWFKLQJRII
LVFDOOHGXSDJDLQRUWKHSURPSWIRU3,1HQWU\FRPHVXSLIWKHODVWPHQXZDV3,1SURWHFWHG
+ Press key ON / OFF on the Front Panel or Control Unit GB 4000C (see figure).
.H\ 212)) .H\ 212))
switches the transceiver on
(but not off), or during opera-
tion switches the display off
and on again
switches the transceiver
on / off