Rohde & Schwarz ZNB - Page 10

Contents
R&S
®
ZNB/ZNBT
10User Manual 1173.9163.02 ─ 54
7.2.1 Device Messages (Commands and Device Responses)............................................ 750
7.2.2 SCPI Command Structure and Syntax........................................................................750
7.2.3 SCPI Parameters........................................................................................................ 754
7.3 Basic Remote Control Concepts............................................................................. 756
7.3.1 Traces, Channels, and Diagram Areas....................................................................... 756
7.3.2 Active Traces in Remote Control.................................................................................757
7.3.3 Initiating Measurements, Speed Considerations.........................................................758
7.3.4 Addressing Traces and Channels............................................................................... 759
7.4 Command Processing.............................................................................................. 760
7.4.1 Input Unit.....................................................................................................................760
7.4.2 Command Recognition................................................................................................761
7.4.3 Data Base and Instrument Hardware..........................................................................761
7.4.4 Status Reporting System............................................................................................ 762
7.4.5 Output Unit.................................................................................................................. 762
7.4.6 Command Sequence and Command Synchronization............................................... 762
7.5 Status Reporting System......................................................................................... 764
7.5.1 Overview of Status Registers......................................................................................765
7.5.2 Structure of an SCPI Status Register..........................................................................765
7.5.3 Contents of the Status Registers................................................................................ 767
7.5.4 Application of the Status Reporting System................................................................774
7.5.5 Reset Values of the Status Reporting System............................................................ 777
8 Command Reference......................................................................... 778
8.1 Special Terms and Notation..................................................................................... 778
8.1.1 Upper/Lower Case...................................................................................................... 779
8.1.2 Special Characters......................................................................................................779
8.1.3 Parameters..................................................................................................................779
8.1.4 Numeric Suffixes......................................................................................................... 779
8.2 Common Commands................................................................................................ 780
8.3 SCPI Command Reference.......................................................................................781
8.3.1 CALCulate Commands............................................................................................... 782
8.3.2 CONFigure Commands...............................................................................................991
8.3.3 CONTrol Commands...................................................................................................999
8.3.4 DIAGnostic Commands.............................................................................................1023