Rohde & Schwarz ZNB - Page 11

Contents
R&S
®
ZNB/ZNBT
11User Manual 1173.9163.02 ─ 54
8.3.5 DISPlay Commands..................................................................................................1025
8.3.6 FORMat Commands................................................................................................. 1051
8.3.7 HCOPy Commands...................................................................................................1053
8.3.8 INITiate Commands.................................................................................................. 1058
8.3.9 INSTrument Commands............................................................................................1060
8.3.10 MEMory.....................................................................................................................1062
8.3.11 MMEMory Commands.............................................................................................. 1063
8.3.12 OUTPut Commands.................................................................................................. 1105
8.3.13 PROGram Commands...............................................................................................1110
8.3.14 [SENSe:] Commands.................................................................................................1113
8.3.15 SOURce Commands.................................................................................................1251
8.3.16 STATus Commands...................................................................................................1299
8.3.17 SYSTem Commands.................................................................................................1302
8.3.18 TRACe Commands................................................................................................... 1345
8.3.19 TRIGger Commands................................................................................................. 1348
8.4 R&S ZVR/ZVABT Compatible Commands.............................................................1355
9 Programming Examples..................................................................1381
9.1 Basic Tasks..............................................................................................................1381
9.1.1 Typical Stages of a Remote Control Program...........................................................1381
9.1.2 Channel, Trace and Diagram Handling..................................................................... 1384
9.2 Condensed Programming Examples.................................................................... 1390
9.2.1 Path Independent RC Programs............................................................................... 1391
9.2.2 Trace and Diagram Handling.................................................................................... 1391
9.2.3 Using Markers........................................................................................................... 1400
9.2.4 Data Handling........................................................................................................... 1402
9.2.5 Calibration................................................................................................................. 1406
9.2.6 Mixer Measurement.................................................................................................. 1412
9.2.7 RFFE/GPIO Interface Programming......................................................................... 1415
9.2.8 Fixture Modeling........................................................................................................1417
10 Error Messages and Troubleshooting............................................1419
10.1 Errors during Firmware Operation........................................................................ 1419
10.1.1 Asynchronous Errors.................................................................................................1420
10.1.2 Errors during Measurement...................................................................................... 1420