Rohde & Schwarz ZNB - Page 1284

Command Reference
R&S
®
ZNB/ZNBT
1284User Manual 1173.9163.02 ─ 54
Suffix:
<Ch>
.
Calibrated channel number. This parameter is ignored; the
parameter is valid for all channels.
<PhyPt> Calibrated port number. This parameter is ignored; the parame-
ter is valid for all sources.
Parameters:
<RecCalPower> Reference receiver cal power
Range: Depending on source power range of the analyzer
and the power range of the external power meter.
*RST: 0 dBm
Default unit: dBm
Example: See SOURce<Ch>:POWer<PhyPt>:CORRection[:ACQuire]
.
Manual operation: See "Reference Receiver Cal Power" on page 494
SOURce<Ch>:POWer<PhyPt>:CORRection:PSELect
<CalPower>
Qualifies how to define the source power which the R&S ZNB/ZNBT uses to perform
the first calibration sweep of the source power calibration ("Reference Receiver Cal
Power").
Suffix:
<Ch>
.
Calibrated channel number. This parameter is ignored; the
parameter is valid for all channels.
<PhyPt> Calibrated port number. This parameter is ignored; the parame-
ter is valid for all sources.
Parameters:
<CalPower> CPOWer | PPOWer
PPOWer – use cal power value defined via SOURce<Ch>:
POWer<PhyPt>:CORRection:PPOWer
CPOWer – use port power value
*RST: PPOWer
Example: See SOURce<Ch>:POWer<PhyPt>:CORRection[:ACQuire]
.
Manual operation: See "Reference Receiver Cal Power" on page 494
SOURce<Ch>:POWer<PhyPt>:CORRection:STATe <Boolean>
Enables or disables the source power calibration for channel <Ch> and for port number
<PhyPt>. The setting command is disabled unless a source power calibration for the
analyzer port has been performed (SOURce<Ch>:POWer<PhyPt>:CORRection[:
ACQuire]). The query always returns a result.
To enable or disable a source power calibration for an external generator use
SOURce<Ch>:POWer<PhyPt>:CORRection:GENerator<Gen>[:STATe].
SCPI Command Reference