Rohde & Schwarz ZNB - Page 854

Command Reference
R&S
®
ZNB/ZNBT
854User Manual 1173.9163.02 ─ 54
CALCulate<Chn>:LIMit:STATe.........................................................................................868
CALCulate<Chn>:LIMit:STATe:AREA............................................................................... 868
CALCulate<Chn>:LIMit:TTLout<Pt>[:STATe]..................................................................... 869
CALCulate:LIMit:CIRCle:FAIL:ALL? [<RecallSet>]
Returns a 0 or 1 to indicate whether or not the circle limit check has failed for at least
one channel in the referenced recall set. 0 represents pass and 1 represents fail
Query parameters:
<RecallSet> Recall set name; if omitted the active recall set is used
Usage: Query only
Manual operation: See "Limit Check" on page 357
CALCulate:LIMit:FAIL:ALL?
[<RecallSet>]
Returns a 0 or 1 to indicate whether or not the limit line check has failed for at least
one channel in the referenced recall set. 0 represents pass and 1 represents fail.
Query parameters:
<RecallSet> Recall set name; if omitted the active recall set is used
Usage: Query only
Manual operation: See "Limit Check" on page 344
CALCulate:LIMit:FAIL:DATA? <TraceName>, <LimitFailType>
Returns those sweep points that have caused a limit violation of the given <LimitFail-
Type> for trace <TraceName>.
Query parameters:
<TraceName> Trace name, uniquely identifying the related trace
<LimitFailType> LIMit | RIPPle | CIRCle
Limit (fail) type
Usage: Query only
CALCulate<Chn>:LIMit:CIRCle[:STATe] <Boolean>
Switches the circle limit check on or off.
Suffix:
<Chn>
.
Channel number used to identify the active trace
Parameters:
<Boolean>
SCPI Command Reference