ROHRBACK COSASCO SYSTEMS CHECKMATE - Page 29

READING ER PROBES
25
Custom Probe Setup
CHAPTER 6
Probes may also be congured manually by following the procedure below:
From the Standby display, press SetUp (F4) to go to the Mate Conguration display:
Press Man Conf (F1) to go to the Enter Probe ID display:
Enter a number between 51 and 255 and press Enter (F1) to go to the Enter Probe
Tag display.
Note: If an invalid ID is entered, it is automatically cleared upon pressing Enter (F1).
Note: If the ID selected has already been congured, the This ID Already Congured
display appears: