13
Product Disassembly and Cleaning
The following cleaning steps should be carried out when the appliance is switched off.
Roller brush assembly, disassembly, and cleaning
First, turn the appliance over, press the roller brush cover release buttons
simultaneously. Remove the roller brush cover, take out the roller brush and clean it.
Use a cleaning brush to clean and cut out the hair and fibres entangled on the roller
brush. It is recommended to change the roller brush every 3-6 months.
Side brush removal and cleaning
First, turn the appliance over, use a screwdriver to unscrew the screws and take out the
side brush. Use a cleaning brush to pick up and cut the hair and fibre attached to the
side brush to separate it from the side brush. It is recommended to replace the side
brush every 3-6 months. Replace the side brush once done cleaning to ensure the
cleaning effect.
Notes:
• Please replace the side brush according to the original factory configuration, so
as not to affect the cleaning effect.
• Please use a screwdriver carefully when replacing the side brush, to avoid
injuring yourself.
• The cleaning brush has a sharp blade which is used to cut the windings that are
difficult to clean. Keep it out of reach of children.
Removal and cleaning of dust box and filter element
First, open the top cover upwards, simultaneously press the dust box removal button,
and take out the dust box. Then open the dust box, align the dust box on top of the
trash can, and dump the dust. Clean the hard-to-reach corners with a cleaning brush.
The user can decide whether to clean the filter element according to his own use. Take
out the filter element, clean it with a cleaning tool and then reinstall it by the original
order or replace it with a brand new filter element. Rinse the dust box/filter element
with clean water. Replace it after it’s completely dry to prevent dust from clumping and
causing unpleasant odours when used again.
To Next Page
Loading...
