Turning the AX-Edge On
1.
Power-on the equipment in the order of AX-Edge
0
connected devices.
* In order to protect its circuitry, the AX-Edge waits for a while after
being powered-on before it begins operating.
2.
Switch on power to the connected equipment, and raise
the volume to an appropriate level.
* The power to this unit will be turned off automatically after a
predetermined amount of time has passed since it was last used for
playing music, or its buttons or controls were operated (Auto Off
function).
If you do not want the power to be turned off automatically, disengage the
Auto Off function.
&
“Making the Power Automatically Turn Off After a Time (Auto Off)”
(p. 8)
5
Unsaved data is lost when the power turns off. Before turning the
power off, save the data that you want to keep.
5
To restore power, turn the power on again.
Turning Off the Power
1.
Power-off the equipment in the order of the connected
devices
0
AX-Edge.
Adjusting the Overall Volume
(Master Volume)
Adjusts the overall volume.
1.
Adjust the [MASTER VOLUME] knob located in the neck
control section.
Making the Power Automatically
Turn Off After a Time (Auto Off)
1.
Press the [MENU/WRITE] button.
2.
Use the cursor [
K
] [
J
] buttons to select “SYSTEM,” and
then press the [ENTER] button.
3.
Use the cursor [
K
] [
J
] buttons to select “Auto Off,” and use
the [–] [+] buttons to change the setting.
If you don’t want the unit to turn off automatically, choose “OFF”
setting.
Parameter
Cursor [K] [J]
Value
[–] [+]
Auto Off
OFF, 30min, 240min
4.
To save the setting, hold down the [SHIFT] button and
press the [MENU/WRITE] button.
A confirmation message appears.
Write System ?
[Exit]:N [Ent]:Y
* Save the system settings while the system setting screen is displayed.
You can’t write the system settings unless you’re in the system setting
screen.
5.
To execute, press the [ENTER] button.
If you decide to cancel, press the [EXIT] button.
Replacing the Blade Panel
The AX-Edge comes with one replacement blade panel.
Blade panel
1.
Use the included hex key to remove the screws.
2.
Exchange the blade panel.
3.
Attach the screws.
NOTE
Tightening the screws excessively could damage the panel or the AX-
Edge itself. Take care not to tighten the screws excessively.
Panel Descriptions
8
To Next Page
Loading...
Need help?
General
