Roland CAMM-1 CX-24 User Manual

5
: Indicates information to prevent machine breakdown or malfunction and ensure correct use.
: Indicates a handy tip or advice regarding use.
In addition to the
and symbols, the symbols shown below are also used.
NOTICE
Do not place hands near the platen
while in operation.
Model name
Rating label
Use a rated power supply.
About the Labels Affixed to the Unit
These labels are affixed to the body of this product.
The following figure describes the location and content of these messages.

Roland CAMM-1 CX-24 Specifications

General

Cutting Width	590 mm (23.2 inches)
Blade Force	20 to 250 gf
Repeatability	±0.1 mm
Compatible Media	Vinyl, heat transfer
Software	CutStudio
Interface	Serial
Power Supply	AC 100 to 240 V, 50/60 Hz