Roland D-50 - Page 96

DATA TRANSFER WITH MEMORY CARD
step 4 Select "INT>CARD” with the corresponding Selector Button.
+ Gates Transfer * C Int + Card J
Are sou sure 7. cEnter-Exit3
To cancel the data transfer mode, simply push the Exit Button.
%* When you write data onto a Memory Card for the first time, pushing
the button will show the following indication for a few seconds, but
please carry on the procedure.
Illegal Card
step 5 Hit the Enter Key,
When the data transfer is completed, the Display changes to as
below, then returns to the Play Mode indication.
step 6 Return the Protect Switch on the Memory Cartridge to the ON
position.
%*When the data fails to be transferred to the Memory Card properly,
the Display responds with :
+ Data Transfer + C int + Card J
Verifu Error . CRetryd ¢Cancel>
a ane OS
tf
Retry Cancel
To transfer the data onto the Memory Card again, assign RETRY
with the Selector Button and repeat the transfer procedure after
carefully reading the instructions of the Memory Card.
To leave this mode, select CANCEL with the Selector Button.
b. Patch Transfer to the Internal Memory
All the 64 Patches data stored on the Memory Card can be loaded
to the D—50’s internal memory.
At the same time, Reverb Types (17-32) are loaded.
Step3
Exit Button
Ben