Roland EGX-600 - Service Notes Manual

SERVICE NOTES
Unauthorized copying or transferral, in whole or in part, of this manual is prohibited.
Copyright © 2002 ROLAND DG CORPORATION
Windows and MS-DOS are registered trademark or trademark of Microsoft Corporation in the United States and/or other countries.
EGX-600/400
5893-01
Second Edition
EGX-600/400 ‘02. Jul.
1 Structure & Spare Parts
1-1 ACCESSORIES ............................................................................ 1
1-2 FRAME & CONTROLLER ............................................................ 2
1-3 X AXIS .......................................................................................... 4
1-4 Y AXIS .......................................................................................... 6
1-5 Z AXIS .......................................................................................... 8
2 Electrical Section
2-1 WIRING MAP ............................................................................. 10
2-2 MAIN BOARD ASS’Y .................................................................. 11
2-3 PANEL BOARD ASS’Y ............................................................... 19
2-4 OTHER CIRCUIT BOARS .......................................................... 26
3 Replacement of Main Parts
3-1 SPINDLE MOTOR_REPLACEMENT ......................................... 34
3-2 X AXIS MOTOR_REPLACEMENT ............................................. 37
3-3 Y AXIS MOTOR_REPLACEMENT ............................................. 41
3-4 Z AXIS MOTOR_ REPLACEMENT ............................................ 45
3-5 X AXIS LM GUIDE_REPLACEMENT .......................................... 50
3-6 Y AXIS LM GUIDE_REPLACEMENT .......................................... 54
3-7 X BELT_REPLACEMENT .......................................................... 59
3-8 Y BELT_REPLACEMENT .......................................................... 64
4 Adjustment
4-1 Special Tools ............................................................................. 68
4-2 SERVICE MODE ........................................................................ 69
4-3 HOW TO UPGRADE FIRMWARE ............................................. 72
4-4 X BELT TENSION ADJUSTMENT ............................................. 75
4-5 Y BELTTENSION ADJUSTMENT .............................................. 77
4-6 RIGHT ANGLED ADJUSTMENT OF X RAIL ............................. 79
4-7 CALIBRATION............................................................................ 80
4-8 X AXIS LOAD CHECK ................................................................ 83
4-9 Y AXIS LOAD CHECK ................................................................ 84
4-10 Z AXIS LOAD CHECK ............................................................... 85
5 Supplemental Information
5-1 OPERATIONAL SEQUENCE ..................................................... 86
5-2 SENSOR MAP ............................................................................ 88
6 Troubleshooting
6-1 POOR ENGRAVING RESULT ................................................... 89
6-2 NOISE ........................................................................................ 91
6-3 SPINDLE LOCK.......................................................................... 92
6-4 MOTOR ERROR (X, Y, Z Axis) .................................................. 93
7 Service Activities
7-1 INSTALLATION CHECK LIST .................................................... 94
7-2 MAINTENANCE CHECK LIST .................................................... 98
7-3 Specification ............................................................................... 99
Contents
Structure & Spare Parts
Electrical Section
Replacement of Main Parts
Adjustment
Supplemental Information
Troubleshooting
Service Activities
1
2
3
4
5
6
7