Roland FC-200 - MIDI Data Transfer Operations; Sending FC-200 Settings via Bulk Dump

30
DATA TRANSFER USING MIDI
You can use System Exclusive (SysEx) messages to send the FC-200’s settings to another MIDI device. This makes it possible,
for instance, to reproduce identical settings on another FC-200, or to save the settings on a MIDI sequencer or some other
piece of equipment.
Sending Data (Bulk Dump)
This sends the settings for the FC-200 to another FC-200 or some other external MIDI device.
Making the Connections and Getting Ready
For Storage on a MIDI Sequencer
Make the connections as shown below, and get the MIDI sequencer ready to receive System
Exclusive (SysEx) messages.
MIDI INMIDI OUT
* Refer to the MIDI sequencer’s manual for instructions on how to operate the sequencer.
For Copying Data to Another FC-200
Make the connections as shown below, and make sure that the sending FC-200 and the receiving
FC-200 are set to the same MIDI channel (device ID).
MIDI OUT MIDI IN