22
Chapter 1 Playing the Keyboard
Adding a Variety Effects to the Sound
In addition to reverb, you can apply a variety of changes to the FP-2’s
sounds.
These are referred to as “effects.” With the FP-2, you can select from ten
different effect types.
With the factory default settings, effects have been preselected for each tone.
fig.01-19
1.
Press the [Effects] button, getting its indicator to light.
Try fingering the keyboard.
The effect is applied to the currently selected tone.
2.
To remove the effect, press the [Effects] button once more,
extinguishing the indicator.
■
Changing the Depth of Effect
You can select from ten levels of depth for the effect.
1.
Hold down the [Effects] button and press the [-] or [+] button.
The depth for the effect being applied to the currently selected tone appears
in the display.
The next time you choose the same tone, the effect with the depth you’ve
selected here is applied.
NOTE
Effects may not be applied
with some of sounds.
1,2
Some tones initially have
effect applied. Selecting
such a tone makes the
[Effects] button’s indicator
light up automatically.
You can specify which part
is to have priority when the
effects assigned to the
Upper Tone and the Lower
Tone differ. Refer to
“Setting the Part to Which
Effects Are Added” (p. 41).
NOTE
You cannot change the
levels of depth for the
rotary effect.
While holding down...
Press
You can change the effect
type. Refer to “Changing
the Effect Type” (p. 40).
FP-2_e.book 22 ページ ２００４年１１月２６日 金曜日 午後４時２５分
To Next Page
Loading...
Need help?
General
