Press the USER PROGRAM 3 button again, you will hear an acoustic signal only on the
right ( R ) OUT DIRECT ¨ basing upon the frequency selected by means of the User
Prog. 1 button.
Press the USER PROGRAM 2 button again, you will hear an acoustic signal on the right (
R ) and left ( L ) OUT DIRECT outputs
¨ basing upon the frequency selected by means of
the User Prog. 1 button.
Note: The measurements on the R/L outputs have to be carried out with the jacks
inserted into the outputs, basing upon the MAIN or DIRECT output selected. The sounds
heard from the R/L Mono channels are mixed and may be adjusted by means of the
MASTER VOLUME potentiometer.
Basing upon the OUT output selected, a sinusoidal wave sound comes out of the RIGHT
and LEFT channels with a frequency and amplitude expressed in Vpp measured by the
oscilloscope.
OUTPUT LEVELS ON THE L/R MAIN OUTPUTS
User Pgm 1 Button Wave shape Frequency (Hz) L/R Output L Output R Output
1 SINE WAVE 100 Hz 1.8 Vpp 2.7 Vpp 2.7 Vpp
2 SINE WAVE 1000 Hz 1.7 Vpp 2.5 Vpp 2.5 Vpp
3 SINE WAVE 5000 Hz 0.3 Vpp 0.42 Vpp 0.42 Vpp
OUTPUT LEVELS ON THE L/R DIRECTOUTPUTS
User Pgm 1 Button Wave shape Frequency (Hz) L/R Output L Output R Output
1 SINE WAVE 100 Hz 1,5Vpp 2,2 Vpp 1,8Vpp
2 SINE WAVE 1000 Hz 1,7Vpp 2,4 Vpp 1,8Vpp
3 SINE WAVE 5000 Hz 0,3Vpp 0,4 Vpp 1,8Vpp
To revert, press EXIT.
2.4 - WAVE&SRX CARD
x Press the USER PROGRAM 3 button, the display shows:
**** WAVE ****
Wave ROM 0 OK
Wave ROM 1 OK
Wave ROM 2 OK
Wave ROM 3 OK
Wave ROM 4 OK
Wave ROM 5 OK
Found SRX : SRX –03 Studio SRX
Checksum : ACDFA4AE
Press EXIT to Skip
To Next Page
Loading...
