Roland G-70 - Bender Calibration

G-70
43
2.7 - METRONOME
Remain in the main video (**** AUDIO OUTPUT ****) and press the USER PROGRAM 7 button,
a METRONOME sound will be heard coming from the OUT Metronome output of the G-70.
Action : Insert the headphones into the appropriate OUT Metronome socket located in the
rear of the bottom cabinet. Pressing the USER PROGRAM 7 button, a Metronome sound
will be heard in the headphones: check the volume adjustment by means of the
potentiometer placed near the socket.
2.8 - WAVE – SRX COMPLETE ( Take long time )
x Press the USER PROGRAM 8 button, the display shows:
If the SRX card has been inserted into the appropriate slot located on the right side of the
bottom cabinet, the test senses the type of card and its checksum.
The display will show OK or ERROR.
Pressing EXIT, the instrument will revert to the main video.
3 - KEYSCAN TEST
x Press the USER PROGRAM 3 button, the display shows:
Pressing any key of the keyboard will make a piano sound be heard.
The display will show the number of the key (XX) and the dynamics value (XXX).
Pressing EXIT, the instrument will revert to the main video.
7 - PITCH CALIBRATION
x Press the USER PROGRAM 7 button, the display shows:
Place the Bender lever at the center and press the SET LIST SW button, the display will
show:
**** WAVE COMPLETE ****
Wave ROM 0 OK
Wave ROM 1 OK
Wave ROM 2 OK
Wave ROM 3 OK
Wave ROM 4 OK
Wave ROM 5 OK
Found SRX : SRX –03 Studio SRX
Checksum : ACDFA4AE
Press EXIT to Skip
**** KEYSCAN ****
Note num : XX
Velocity : XXX
Press EXIT to Skip.
** BENDER CALIBRATION **
Calibrating the CENTER POSITION :
Release The Pitch Bend lever, Press LIST SW
** BENDER CALIBRATION **
Calibrating the HARD LEFT POSITION :
Move Pitch Bend lever to the left and press LIST SW