27
Chapter 2 Creating Your Own Settings (Patches)
Copying Patches
You can take the settings in a patch and copy them to a
different patch.
1. Confirm that the GI-20 is set to “PLAY MODE.”
If the GI-20 is not set to “PLAY MODE,” then turn the
PARAMETER knob to “PLAY MODE.”
2. Select the copy-source patch (refer to “How to Switch
Patches” on p. 13).
3. Press [WRITE].
The display flashes.
fig.02-50
4. Press [PATCH/VALUE] to select the copy-destination
patch.
* To cancel the Copy procedure, press [SELECT (EXIT)].
5. Press [WRITE] once more.
The settings are stored in the copy-destination patch.
* Note that once the Copy procedure is carried out, any settings
that had been stored in the copy-destination patch are
permanently lost.
Flash
To Next Page
Loading...
Need help?
General
