Roland GK-2 - Installation; Important Notes

[1] INSTALLATION
Before installing the GK-2 with the electric guitar,
read the following “Important Notes”.
E IMPORTANT NOTES
e |f your guitar is provided with a tremolo arm,
attach the tremolo arm before setting up the
GK-2.
e Before removing the tremolo arm from your
guitar, set the Selector Switch on the GK-2 to
the “Guitar” or “Synth” position.
è Please adjust the wrap of the neck and the
height of the strings of the guitar body before
installing the GK-2.
@ Please try placing the Divided Pickup and the
Pickup Controller Unit on the guitar to see if
they are compatible before actually connecting
them. At first please confirm with adhesive
tape and if there is no problem on installation,
then fix GK-2 with the screws.
e |f the pickup on the guitar is too close to the
bridge to connect the Divided Pickup, you need
to shift the pickup towards the neck.
@ Please use the screws for fixing the GK-2 more
securely. Attaching with the adhesive tape
many not be sufficient. The adhesive tape may
come off with the coating of the guitar.
(The supplied both-sided adhesive tape may be
used just for experimenting the right position of
the GK-2.) ;
@ Please handle the divided pickup gently. Bend-
ing or twisting it will break the coil.