Roland HP 1300e - Roland Piano Troubleshooting & Specs; Piano Troubleshooting Guide; HP1300 e;HP1600 e Technical Specifications

Troubleshooting, —@#@@#@"© “CIRIE men
Whenever you suspect that the instrument is not performing as it should, please consult the following information.
Q. No sound heard from speakers.
A. + Have you checked to make sure you don't have the volume set at “MIN”?
«Do you possibly have headphones connected?
^if using other connected MIDI devices, have you made sure the power È
elf in the Multi-Timbral mode, do you have the Transmit channel set to
ON for all such devices?
Q. The damper effect is constantly applied to notes played (they continue sounding longer than normal). Or, the damper
effect cannot be obtained at all.
A. Have you checked to make sure the cable from the stand is connected properly to the piano?
Refer to “Assembling the KS-1300€/1600e Stand for the HP-1300e/HP-1600e,” page 4.
Q. Notes played on the keyboard are too high for low) in pitch,
A. *Have you checked to make sure that key transposition is not in effect? (If Key Transpose has been set, the indicat
on the FUNCTION button will be lit.)
To exit the transposed state, press the FUNCTION button. (lts indicator should be out.)
e Do you have the Master Tuning set appropriately?
or
Q. Data that was in the recorder has disappeared.
A. «The performance data that you record into the recorder will be erased approx. 8 hours after power is turned off.
Regrettably, there is no way to restore such data once it has been erased. If you need a more permanent form of
storage for your songs, you will need to use a sequencer {eg., Roland MC-SOMKII or MT-200) and store songs on
floppy disks.
«Have you possibly pressed the PLAY and REC buttons at the same time?
Q.The pitch differs from what it should be with “ISM” related products, or another manufacturer's sound generating
unit.
A. Check to make sure that the Tuning knob on the rear of the unit hasn't been inadvertently moved.
Adjust the tuning knob until the piano’s pitch matches that of the external units you are using.
Q. Operations you perform using the panel buttons (Chorus/Reverb/Voice selections) cannot be stored into a sequencer.
A. Have you made sure you have the Transmission/Reception Mode set to Mode 3? Note that each time power is turned
on, the unit will by default be in Mode 1. In order to record operations you perform using the panel buttons, the
piano must be set to Mode 3.
Keyboard 88 weighted keys (with mechanical Speakers 16cmX2
hammers on HP-1600e) Output 15WX2
Sound Source Advanced SA Process Finish Simulated Rosewood
Voices Piano Power Consumption 50 W (120V), 40 W (230, 240V)
Harpsichord Dimensions :Piano 1436 (W) X 456 (D) X 176 (H) mm
Vibraphone Stand 1436 (W) X 456 (D) X 638 (H) mm
Electric Piano Total 1436 (W) X 456 (D) X 814 (H) mm
Pipe Organ Weight ‘Piano 32.0 Kg
Strings Stand 15.3 Kg
Effects Chorus (6 levels) Total 47.3 Kg
Reverb (6 levels) Supplied Accessories Owner’s Manual, Power Cable,
Touch
Control
Light
Keyboard
Stand
(KS-1300e/1600e)
Medium
Heavy
Controls Volume, Brilliance, Master Tune, = In the interest of product improvement, the specifications
Key Transpose of this unit are subject to change without prior notice,
Connectors Output Jacks (Stereo)
Input Jacks (Stereo/Mono)
Pedal Jacks
MIDI IN Connector
MIDI OUT Connector
Headphones Jack
Pedals Damper, Soft / Sostenuto