4
Turning on the JUNO-Gi
1 With the JUNO-Gi still turned off, turn on any listening equipment to
which it’s connected, and set the equipment normally.
2 Turn the JUNO-Gi’s main VOLUME knob all the way down.
3 Press in its rear-panel POWER button to turn on the JUNO-Gi.
If you’re in playing position and feeling around for the POWER button
on the back of the JUNO-Gi, it’s just to the left of the DC IN jack.
After power-up, you’ll see the JUNO-Gi’s Live Set Play screen.
The Live Set Play screen is an important one—it’s essentially the
JUNO-Gi’s synthesizer Home screen. You can always get back to it by
repeatedly pressing the EXIT button to the right of the JUNO-Gi display.
If this doesn’t get you all the way back, press the RECORDER VIEW
button in the DIGITAL RECORDER area once or twice.
4 Play the JUNO-Gi’s keyboard as you turn up its VOLUME knob to a
comfortable listening level.
3 Gently press the door’s tabs inward, and then lift out the door.
4 Insert eight fresh batteries according to the polarity symbols shown
in the battery compartment. The JUNO-Gi will successfully power up
only when you’ve got the batteries the correct way.
For optimal results, avoid mixing new and old batteries. Fresh
batteries are always best, of course.
5 Re-attach the compartment door by inserting its far edge, and then
gently pressing down the door so its tabs lock in place.
If you reconnect the adapter while operating on batteries, the JUNO-Gi
momentarily shuts down to switch power sources.
6 See “Turning on the JUNO-Gi” below.
To Next Page
Loading...
