Roland JUNO-X Startup Guide

8
1
[VOLUME] knob
Adjusts the overall volume.
PORTAMENTO [TIME] knob
Changes the speed at which the pitch changes when portamento
is on.
PORTAMENTO [ON] button
Selects whether the portamento effect is applied to the notes that
you play.
2 I-ARPEGGIO section
[TEMPO] (SHUFFLE) knob
You can specify the tempo of the arpeggio.
Also, you can press the [PART/FUNC] button to make it light up blue
and then turn the [TEMPO] (SHUFFLE) knob to adjust the shuffle
feel of the sound.
[DURATION] knob
You can specify the length during which each of the arpeggiated
notes is heard. Shortening the duration produces a staccato feel,
and lengthening the duration produces a tenuto feel.
* The [DURATION] knob changes the value for all parts at the same time.
PART [MODE] (P-STYLE) knob
Selects the arpeggio mode for parts 1–5. The mode you select
changes how the arpeggio plays.
Also, you can press the [PART/FUNC] button to make it light up
blue and then turn the PART [MODE] (P-STYLE) knob to set how the
probability (*) changes. Turn the knob all way counterclockwise to
switch this off.
PART [STYLE] (P-AMOUNT) knob
Selects the arpeggio pattern for each part.
You can also press the [PART/FUNC] button to make it light up blue
and then turn the PART [STYLE] (P-AMOUNT) knob to adjust how
much probability (*) is applied.
(*) What is “probability”?
The probability setting changes the randomness of the notes that sound
when you are using the I-ARPEGGIO function, giving the notes a more human
feel. By changing the P-STYLE settings, you can alter the timing at which notes
are played with a more random feel; and by adjusting the P-AMOUNT setting,
you can change how often the notes play.
[HOLD] button
Turns the hold function on/off.
When the hold function is on, the sound of the last-played key is
held.
PLAY DETECTOR [KEYS] button
When this button is on (lit), the constituent notes of the arpeggio
change according to the chords you play on the keyboard.
PLAY DETECTOR [BEAT] button
When this button is on (lit), the arpeggio pattern changes
according to the timing at which you play the keys.
3 LFO (low frequency oscillator) section
[TYPE] knob
Selects the LFO waveform.
[RATE] slider
Specifies the LFO’s modulation speed.
[DELAY TIME] slider
Specifies the time from when the tone sounds until the LFO
reaches its maximum amplitude.
[DEPTH] slider
This specifies the depth of the LFO.
[PITCH] button
When this button is on (lit), you can use the [DEPTH] slider to adjust
the intensity of the vibrato.
[FILTER] button
When this button is on (lit), you can use the [DEPTH] slider to adjust
the intensity of the wah effect.
[AMP] button
When this button is on (lit), you can use the [DEPTH] slider to adjust
the intensity of the tremolo effect.
4 OSC (oscillator) section
[PWM/MOD] slider
Changes the waveform modulation, such as the duty cycle of the
square wave.
[ ] slider
Adjusts the level of the square wave or asymmetrical square wave.
Panel Descriptions
Top Panel
12
1 2 3 4 5 6 7 8 9
10
11
10
* Some buttons, knobs or sliders may be disabled depending on the model you select.

Roland JUNO-X Specifications

Keyboard Specifications

keyboard keys	61 keys
preset tone	4000 or greater
user tone	256

Effects and Sound Generators

multi-effects systems	4 systems
multi-effects types	93 types
reverb types	8 types

Bluetooth and Display

bluetooth profile support	A2DP (Audio), GATT (MIDI over Bluetooth Low Energy)
codec	SBC (Support to the content protection of the SCMS-T method)
display resolution	128 x 64 dots

Speakers and Amplifiers

speaker amplifier power	4W x 2
full range speakers	3.5 x 8 cm x 2
tweeter size	2 cm x 2

Connectors and Ports

headphones jack	Stereo miniature phone type (front), Stereo 1/4-inch phone type (rear)
main out jacks	1/4-inch phone type, XLR type
mic input jack	1/4 inch phone type/XLR type

Weight and Dimensions

dimensions	1072 (W) x 333 (D) x 118 (H) mm
weight	11.6 kg
power consumption	20 W