Roland JV-30 - Page 23

Setting Performance Functions
for Individual Parts
O
Reverb Send Depth
l^Piano 1
Re
'..'
e- r b Def- t- hi : 48
Sets the manner in which
Reverb
will
be applied for each Part.
The acceptable range
is
0-127.
0MIDI
These
settings are for functions
which come into play
when you connect this instru-
ment
with another MIDI-equipped
unit. For details, refer
to "MIDI Settings" (»
p.34).
Control
O
Bend
Range
ll^-Piano 1
Bend Ran9e
:
+16
O
Modulation
Depth
l^Piano 1
Nod Dep+_h-i: 2Q
O
Key Shift
iP^Piano 1
Key Shift:
--i-
2
O
Velocity Sens
Depth
l^Pi an.:. 1
Uel.D Depth: 64
O Velocity Sens Offset
lS.-Pian.D i
Ki
e 1 o
ID
f f s- et : 64
Allows settings
to be
made for the following
functions:
Determines the amount of pitch change obtained when the Bender/Modulation
Lever is moved
to
either
the left or right extreme. The setting is in semitones, and
a
maximum of 2 octaves is possible
(0
to
+24).
Sets the depth of the vibrato obtained when the Bender/Modulation
Lever is pushed
all the
way to
the rear.
The
range
for the value is
0-1
27. The higher the value, the
deeper the vibrato becomes.
Allows the pitch to be shifted in semitones. The setting can be
within the range of
±2
octaves (-24
to
+24).
On the JV-30, the strength
(velocity)
with which you play the keyboard is translated
into alterations in the volume or timbre of the sound. The Velocity Sens Depth
set-
ting determines the extent
to
which such alterations will
occur. With the setting at
a
high value, the changes in volume will
be
quite pronounced; whereas
if set to
"0,"
there will
be
no change in volume no matter how hard
you
play the
keys. The
range
of the value is
0-1
27.
This setting determines the approximate velocity at which the keys should be struck
in order to obtain
alterations in the volume. With values greater than
64,
volume
fluctuation occurs even when the keys are pressed
lightly.
With values lower than
64,
volume
fluctuation occurs when the keys are pressed firmly. The range of the
value is
0-127.
O
Voice Reserve
'.,.1
i~i
JnZ-^ P
pi
3
'-
1"
"'
' '
.^
Parti:
The
rest
of
voice number
The Voice Reserve number
(current part)
Sounds may not be output
depending on the settings. If this occurs, set
the
Velocity Sens Depth or Velocity Sens Offset to higher values.
This setting
determines the minimum number of voices
that will always
be
reserved
and
made
available
for
a
certain Part. This is for situations
where the total number
of voices
being sounded
has
exceeded
the JV-30's maximum
polyphony.
For example,
if Voice Reserve is set to
"6"
for
a
particular Part, that Part will always
be
able to
sound
at
least 6 voices, even
when the unit
as a
whole is being requested
to
produce
more voices than it is capable
of.
*
Since the JV-30 is capable of
producing 24 voices simultaneously, the values
set
for Voice Reserve for all Parts combined must add up to 24 (or less).
23