Troubleshooting
In cases when for some
reason no
sound
is produced,
or you
think
the unit is
not operating as it
should, first check the items below. Then, if
you should still
be unable to achieve
normal operation, contact
the store where you bought
the instrument, or the nearest Roland
Service
Station.
No sound
produced/
^
^'^^
y*^"^
^^^^
y*^'^
don't have the volume set too low?
_-|.„
J
tnn lf»\A/
Recheck the
volume settings
you
have on this unit, and any amplifier or mixer you have
50Unu XOO low
connected.
Can sound be
heard through headphones?
If so, then you may
have
a
cord that is damaged, or the
amplifier
or
mixer
you
have con-
nected is the
source of the problem.
Check the cable{s) being
used,
and the equipment you have
connected.
9
Are you
sure
you
do not have the
Local Control MIDI parameter set to OFF?
Set
it to Local ON (» p.35).
Are
you
sure the value set
for Master/Parts is not too low?
Recheck Master Level (»
p.20)
and Part Level
{» p. 22).
Is it possible that the
volume for Parts is being set too low as a
result of Volume
messages
received from an external
device?
Try changing the
Part.
Are you
sure the Transmit
channel is matched with the Receive
channel
used by
the
other device?
Refer to "Transmit
Channel" (»
p. 34),
and
"Receive Channel"
(» p.35).
The
Ditch is not
riaht
^
Could the setting
for Master Tuning
possibly
be
wrong?
Check the
setting.
Are you
sure you don't
have Transpose set to
"ON"?
Press (TRANSPOSEl to
turn it OFF.
9
Is the setting
for Key Shift
appropriate?
Check the
setting (»
p. 23).
Is it
possible that Bender
messages are
being continually received?
Try moving the
Bender/Modulation
Lever.
Tones don't
chanae
^
^''^
y°"
^"'^^
y*^"^
^^
"°* ^^^^
''^^^'
^*^"*''°'
^^*
^°
^^^^
^
Set
it
to
Local ON (» p.35).
properly
Could you have the
Tone Change
Receive
Switch set to OFF?
Set
the Tone
Change Receive
Sw/itch to ON.
Could you possibly be
in the
ROM Play mode?
Press [LEVEL] and
[PAN]
simultaneously
to
exit the ROM
Play mode.
Effects
do not
work
•
^""^
y^^
^"''^
^^^
'®^^' ^^*
^°'' chorus/Reverb
for
Master/Parts is not too low?
Recheck
the settings.
Are the
indicators on
relevant Effects
On/Off switches
(Chorus,
Reverb) lighted?
Press their
buttons
to
turn them
ON.
45
To Next Page
Loading...
