Roland M-16E - Page 11

@Peak/Signal Indicator
This indicator lights in green when any signa! is fed
into the Input Socket, and changes to red if the level
of the signal is too high.
It lights in green at —16dB which is the rated level
and lights in red at —6dB which is a clipping level.
* The Peak/Signal indicator aiso supervises the jeve! of
the signal after it passes the Equalizer section.
@Sens Control Knob
This adjusts the input sensitivity depending on the
level of the input signal. Adjust this knob so that the
Peak/Signal Indicator normally lights in green and
occasionally in red. If the Peak/Signal Indicator does
not light up at all, rotate the Sens Contro] Knob
clockwise(ta boost the input sensitivity) or increase
the input level.
* The Rated Input varies from ~50dBm to +4dBm.
@Equalizer Control Knobs
These contro! knobs adjust the tone of the input
sound.
@High: This controis the higher range
sounds : 10kHz frequency can be
controlled up to +15dB.
@Mid : This controls the middle range
sounds : 200Hz to 5kHz frequency
can be controlled up to =16dB.
@Mid Frequency :The frequency of the Mid Equalizer
can be varied from 200Hz to SkHz.
@Low: This controls the jower range sound
: 100Hz frequency can be controlied
up to +15dB.
16}
+20
MID(SKH2) HIGH
|
Ha
20 : so 100 200 S00 IK 2k 5h OK 20K THz)
@Effect Volume
This adjusts the level of the signal to be sent to the
Effect Send. At the center position, the output level
is zero for both EFF } and EFF 2. Rotating the knob
counterclockwise adjusts EFF 1's level, while rotating
it clockwise adjusts EFF 2's level.
* The signal is sent to the Effect Send post fader (after
the Channe! Fader).
@AUX Volume
This adjusts the level of the signal sent to the AUX
Send.
* The AUX Select Switch (iocated at the Master section)
can select whether to send the signal to the AUX
Send before (PRE} or after (POST) the Channel Fader.
@Monitor Volume
This adjusts the level of the signal to be sent to the
Monitor Send.
*The signal is sent to the Monitor Volume pre fader
(before the Channel Fader).
@Panpot
This sets the position of sound imaging in stereo
field. At the center position, the volume of the L and
R are equal.
@Channe! On Switch
Pressing this switch down(Channel On) will send
signal to the Master Section.
%* Where the signal is turned on or off is pre fader.
* When the Channel On Switch is set to off, no signal
is sent out.
@Channel On Indicator
This lights in green when the Channel On Switch is
pressed down(Channel On).
@Channe! Cue Switch
This switch sends signals to the Headphones or Cue
Out.
* The signal is passed from the pre fader stage.
* Then the Channel Cue Switch is set to off, no signal
is sent out.
@®Channel Fader
This adjusts the level of the signal sent from the
channel.
%*In the Channel Faders, “10° is the rated output.