Roland M-16E - Master Section

2. Master Section
@Master Peak Meter
This supervises the level of the signal output from
the Master Out. When “0dB” is lit, +4dBm ievel is
Roland
MABE...
output
from
the
Master
Out.
oo
@Monitor/Cue
Peak
Meter
This supervises the level of the signals output from
the Monitor Send and Cue Send. Usually, the output
jevel of the Monitor Send is indicated, while the
output level of the Cue Send is shown when the Cue
Switch is pressed down.
When “QdB” is iit, +4dBm ievel is output from the
Monitor Send or Cue Send.
* Where the monitor signal is checked is after the
Monitor Send Voiume.
* Where the cue signal is checked is before the
Headphone/Cue Volume.
© Pre Fader Signal Indicators
These supervise the output level of the signal sent
from the amplifier where the signals(L and R) from
each channel are mixed. The signal is checked before
the Master Fader. At the rated level -20dB, it lights
‘ in green and at the clipping level —6dB, lights in red.
3 =
2
=
i
=) (Ss)
AUX SELECT
mF MOST
@Return Volume Contrals
) &)
These adjust the level of the signal fed into the
1
Return Sockets.
@RTN3-4 Level Switch
This selects the input level of Returns 3 and 4.
* Select either +4d8m or —20dBm depanding on the
~)
q
connected device,
@Master Cue Switch
This switch sends the signals to the Headphones or
Cue Out.
* The signal is passed from the pre fader stage (before
the Master Fader).