Roland M-16E - Rear Panel

3. Rear Panel
a
PHANTOM
3. fuopaaans:
A
© © ©) bd 6 )) 5 Zz
0 re
LOS ae ae }| _
@input Connectors
These are XLR(balance) type input connectors.
Connect microphones, musical instruments, etc. When
both Input Socket and Connector are used at the same
time for one channel, the Input Socket has priority.
@Phantom Switches
These are the power supply switches for condenser
microphones that require external power supply.
When you do not use a condenser microphone, be sure
to set the relevant switch to the OFF position.
When these are set to the ON positions. the Input
Connector “1” (ground), “2"(cold) and “3” (hot) carry
on 48VDC,
When connecting or disconnecting a microphone cable,
be sure to set the switch to the OFF position.
* Channels 9 to 16 carry 48VDC on the Input Sockets. if
you happen to connect to standard phone sockets by
mistake without the Phantom Switch set to OFF,
damage may be caused to devices. Be especially
careful while you have the “Fhantom Switch’s
Cover” (4: off.
@input Sockets
Connect microphones. electronic musica] instruments.
etc, to these sockets.
Use stereo standard plugs for balance input.
12
%* Use standard phone plugs for unbalanced input.
*When connecting condenser microphones to the
Channels 9 to 16 that require phantom power supply,
use the input cable (PCS-30). Then remove the
Phantom Switch’s Cover, and set ON only the
switches for the channels that use the phantom
power.
CANNON XLR-3-11C