Roland M-16E - Page 15

@insert Sockets
These are inpui and output sockets for connec’
effect vw each channel. These can alse be used for
direct output from channels
%*The signal is output after the Equalizer and before
the Channel On Switch.
%* Use Insert Cable (PCS-31) for connecting an effect
unit and @ standard phone cable for using as @ direct
output,
SEND
RETURN
GND
RETURN(RED) SEND(BLACK)
Freer en
@Return Sockets
The
signa]
returned
from
an
effect
unit
is
input
through
a
Return
Socket.
These
sockets
can
also
be
used
for
auxiliary
inputs.
A
Return
Socket
1s
stereo
input,
but
can
be
used
as
a
standard
phone
plug
(mono)
by
using
only
the
L
side.
@Rec Out Sockets
These are output sockets for connecting a tape
recorder, etc. The Rec Out Sockets cannot perform
monitor playback and recording at the same time.
%* When recording onto a tape recorder, oscillation
may
occur
when
the
playback
sound
on
the
tape
recorder is returned to the mixer. Set the Input
Volume Control where the tape recorder is connected
to zero or disconnect it.
*The signa! is output before the Master Fader(pre
fader).
@Master Out Sockets
These are output sockets for connecting 4 power
amplifier, etc.
GETTECT SeNc SOCKETS
These are for sending signa! to an effect unit
@AUX Send Socket
This sends signa! to an effect unit or monitor.
@Monitor Send Socket
This sends signal to a monitor.
@Cue Send Sockets
Cue signal is sent through these sockets.
%* When the Cue Switch is not used, the signal from the
Master Out(pre fader) is output.
@Bus In Sockets
These can be directly connected to the Effect Send.
AUX Send, Monitor Send and Master(L and R)
busses for mixing. When stacking two mixers, you
can extend the input channels by feeding signals to
the Bus In Socket on the master mixer from the Send
or Master Out on a slave mixer.
@®Master Out Connectors
These are XLR(balance) type output connectors for
connecting a power amplifier, etc.
* There are two types of XLR connectors’ pin stand-
ards; USA and Europe types.
This unit adopts USA type(1st:GND, 2nd:COLD,
Q@rd:HOT). When connecting this unit with other
devices, make sure the pin standard of the devices
match this unit's.
@ D ® @)
3 3
+:GND
2:COLD
3:HOT