Roland M-16E - Connections and Operation Sree; Mbinitial Procedure Vrrvessestrrererersesseeceretsenecenes

IMPORTANT NOTES
Power SuppiyO
@The appropriate power supply for this unit is
shown on its name plate. Please make sure that the
line voltage in vour country meets the requirement.
@o not use the same socket used for any noise
generating device (such as a motor or variable
lighting system.)
@Make sure that the unit is turned off before
connecting the power plug to the AC socket.
@Be sure to connect the power cord to the AC socket
on this unit before connecting the power plug to the
wall socket.
@When disconnecting the power plug from the socket.
do not pull the cord but hold the plug to avoid
damaging the cord.
@ Avoid damaging the power cord.
@If the unit is not to be used for a long period of
time, unplug the cord from the socket.
@lt is normal for this unit to become hot while
being operated.
@Check with vour local Roland dealer. if you wish to
use this unit in another country.
@ Disconnect the AC cord immediately in the event of
an electrical storm.
@Pin connection of the XLR type connector is
standardized to the Ist pin-Ground. the 2nd pin-Cold
and the 8rd pin-Hot of this unit.
Location&
@Be sure to turn on the mixer before turning on the
amplifier. Likewise turn the amphfire off first.
then the mixer. Before taking procedures. set the
faders of the mixer to the "0" positions.
@Avoid using this device in excessive
humidity conditions. ar where it may be affected
by direct sunhgnt or dust and avoid places subject
to high vibration.
@Operating the unit near a neon hight. fluorescent
lamp. TV or CRT Display. may cause noise
interference. If sc. change the angle or the positon
get
of the unit.
@lfa device with 6 large-sized transformer. such as
@ power amplifier, is mounted just ahove this
device. hum mav be produced.
@o not place or drop anything heavy on the main
unit or 1ts power cord,
OCleaning CareO
@For cleaning the unit, use a dry and soft cloth.
@If the casing is stained, use a cloth slightly
dampened with water
@7To remove stubborn stains. clean the casing with @
cloth moistened with a nutral detergent, then wipe
it dry with a soft cloth.
@Do not use solvents such as paint thinner when
cleaning.
OOthersO :
@For approximately 3 seconds after the unit is
turned on. the muting circuit functions. therefore
no sound is heard.
@When switching on/off during performance. a click
noise will be produced. There no need ty be
concerned.
€ vou have
@e sure to read page caretutis
the Phantom Switch's Cover off.
@be sure te set the Phantom Switches to the OFF
positions excep? when using a condenser microphone
which requires external power supply