Roland M-16E - As. Channel Section Sree Perrrerererrrrrr Triers Reer Err er Rity; Master Section; Master out; Effect Send

1. Channel Section
The signal fed through an input socket goes to a
balance amplifier. then to a head amplifier, and
finally, its input sensitivity is adjusted at the Sens
Contre! Knob. When signa! is input, the Peak/Signai
Indicator
lights
in
green.
If
the
level
of
the
input
signal is toc high, the indicator changes to red.
The
signal
which
is
level-adjusted
at
the
head
amplifier
is
tone-controlled
at
the
Equalizer
section
(HI,
MID,
LO),
processed
at
the
Channel
Insert,
then
sent
to
the
Channel
Fader.
After
the
Channel
Fader,
the
signal
is
divided
into
L
and
R
at
the
Panpot,
then
sent
to
the
Master
Section.
A
part
of
the
signal
is
sent
to
the
Effect
Volume,
AUX
Volume,
and
Monitor
Volume
before
or
after
the
Channel
Fader,
then
sent
to
the
Master
Section.
2. Master Section
a. Return
The signals fed into Returns 1 — 4 enter the buffer
amplifier,
and
after
passing
through
Return
Volume
and being mixed, are passed to the Master Out.
b. Rec Out
Signals
coming
from
the
channels
are
mixed
then
sent
to
the
Rec
Out
before
going
to
the
Master
Fader.
c. Master Out
Signals coming from the channels are mixed and
level-adjusted
at
the
Master
Fader,
then
sent
to
the
Master Out.
d. Effect Send
Signals coming from the Effect Volumes are mixed,
and
level-adjusted
at
the
Effect
Send
Volume,
then
sent to the Effect Send.
e. AUX Send
Signal
sent
to
the
AUX
Volume
before
or
after(pre’
post)
the
Channel
Fader
is
jevel~adjusted,
mixed
and
further
level—adjusted
ait
the
AUX
Send
Volume,
then
finally
sent
to
the
AUX
Send.
f. Monitor Send
Signal
sent
to
the
Monitor
Volume
prior
to
the
Channel
Fader
is
ievel-adiusted.
mixed.
further
level-adjusted
at
the
Monitor
Send
Volume,
then
sent
to
the
Monitor
Send.
g. Cue Send
The signal sent from the Cue Switch is mixed,
level-adjusted
at
the
Headphone/Cue
Volume
then
sent to the Headphone Socket and Cue Send.
h. Bus In
The
signal
coming
from
the
Bus
In
Socket
is
directly
sent
to
the
mixing
circuits
of
the
Effect
Send,
AUX
Send
and
Monitor
Send
to
be
mixed,
then
sent
to
the
Effect
Send
Volume,
AUX
Send
Volume
and
Monitor
Send
Volume
to
be
finally
output
from
the
respective
Send
Outs.
The signals coming from the Bus In Sockets(L and R)
are directly sent to the mixing circuits to be mixed,
sent
to
the
Master
Fader,
then
finally
to
the
Master
Out.