Roland MKS-20 - Memory

d.
Memory
Cartridge
Using
the
Memory
Cartridge
{M-16C),
the
edited
data
of all
the
banks
(1
to
8)
on
the
MKS-20
can
be
saved.
The
saved
data
can
be
loaded
back
to
the
MKS-20
at
any
time.
1)
Saving
®
Make
sure
the
Protect
Switch
on
the
Memory
Cartridge
is
set to
the
ON
position.
(2)
Securely
connect
the
Memory
Cartridge
to
the
Memory
Cartridge
Holder
Q
on
the
front
panel
with
the
Protect
Switch
side
facing
upward.
.,ss^
Usually,
the
Protect
Switch
should
be
set
to the
ON
position.
@
Set
the
Protect
Switch
on
the
Memory
Car-
tridge
to
the
OFF
position.
Now,
the
Memory
Cartridge
is
ready
to
accept
the
data
from
the
MKS-20's
memory.
®
While
holding
the
Save
Button
®
down,
push
the
Write
Button
®.
When
the
saving
Is
completed,
the
Display
responds
with:
(5)
Return
the
Memory
Protect
Switch
on
the
Memory
Cartridge
to
the
ON
position.
If
the
Memory
Protect
Switch
has not
been
set
to
the
OFF
position,
the
Display
will
react
as
shown
below
and
the
saving
cannot
be
done.
Set
the
Protect
Switch
on the
Memory
Cartridge
to
the
OFF
position.
If this
happens,
set the
Protect
Switch
on
the
Memory
Cartridge
to the
OFF
position,
then
repeat
the
saving
procedure.
15