Need help?Do you have a question about the Roland PNC-900 Camm-1 and is the answer not in the manual?
General| Model | PNC-900 CAMM-1 |
|---|---|
| Interface | RS-232C |
| Power Supply | AC 100 to 240 V ±10%, 50/60 Hz |
| Type | Cutter |
| Max Media Thickness | 0.8 mm |
| Acceptable Material Width | 50 to 700 mm (2 to 27.5 inches) |
| Software Resolution | 0.025 mm/step (0.00098 inches/step) |
| Blade Force | 30 - 350 gf |
| Command System | Roland CAMM-GL |
| Power Consumption | Approx. 50 W |
| Power Requirements | 100 - 240 V, 50/60 Hz |
| Mechanical Resolution | 0.025 mm/step (0.00098 inches/step) |
To Next Page