Roland Camm-1 GR2-640 - User Manual

Thank you very much for purchasing this product.
• To ensure correct and safe usage with a full understanding of this product's performance, please be sure to read through this manual com-
pletely and store it in a safe location.
• Unauthorized copying or transferal, in whole or in part, of this manual is prohibited.
• The specifications of this product and the contents of this operation manual are subject to change without notice.
• The operation manual and the product have been prepared and tested as much as possible. If you find any misprints or errors, please
inform us.
• Roland DG Corporation assumes no responsibility for any direct or indirect loss or damage that may occur through use of this product,
regardless of any failure to perform on the part of this product.
• Roland DG Corporation assumes no responsibility for any direct or indirect loss or damage that may occur with respect to any article made
using this product.
FA02570
R1-210707
http://www.rolanddg.com/
Copyright © 2021 Roland DG Corporation

Summary

Other Cutting

Optimizing Quality and Efficiency

GreatCut-R Software for Optimization

Output Quality Optimization

Addresses material properties and settings impacting cutting quality and performance.

Cutting Efficiently

Reducing Cutting Output Time

Maintenance

Machine Cleaning and Part Replacement

Procedures for cleaning machine components and replacing worn-out parts like blades.

AAS Offset Test

Performing AAS Offset Test

Procedure to perform a test to check and correct the AAS sensor's crop mark reading accuracy.

Adjusting AAS Offset Deviations

Details how to adjust width and length deviations found during an AAS offset test.

What to Do If

Troubleshooting Machine Problems

Troubleshooting guide for common issues encountered when operating the cutting machine.

Cutting Output Problems

Crop Mark Detection Issues

Troubleshooting steps for issues related to the machine failing to read crop marks.

Material Feeding Problems

Addresses problems with unstable or uneven material feeding during operation.

Material Slippage from Pinch Rollers

Material Lifting and Blade Damage

Output Quality Problems

Printing and Cutting Misalignment

Diagnoses and resolves issues where printed graphics and cut lines do not align correctly.

Unclean Cuts or Uncut Areas

Troubleshooting for incomplete cuts or rough edges, often related to blade or settings.

Carrier Paper Cutting Issue

Misaligned Cut Start;End Points

Roland Camm-1 GR2-640 Specifications

General

Model	Roland Camm-1 GR2-640
Power Supply	AC 100 to 240 V ±10%, 50/60 Hz
Maximum Cutting Speed	1, 485 mm/s
Cutting Force	600 gf
Interface	USB 2.0, Ethernet
Maximum Cutting Area	1, 651 (W) x 50, 000 (L) mm
Blade Force	600 gf
Software Resolution	0.025 mm/step
Distance Accuracy	±0.1% of distance traveled, or ±0.1 mm
Repeatability	±0.1 mm
Alignment Accuracy for Print & Cut	±0.1 mm (0.0004 in) or less
Operating Temperature	5 to 40°C
Operating Humidity	35 to 80 % RH (no condensation)
Dimensions (with stand)	73.8 in. (W) x 28.5 in. (D) x 44.5 in. (H) (1, 875 mm (W) x 723 mm (D) x 1, 130 mm (H))