Roland RD-150 - Applying Digital Effects

Note: You can store this setting so that it will be used next
time you switch on the RD-150. There is only one meniory,
however, so that the previous settings will be overwritten
when you store your new panel settings. Hold down
while pressing [CHOIR]. Then confirm by press-
ing DATA [#].
Changing the split point
When you activate the Split mode, the keyboard will
be split at the “Gb3”, i.e. the Gb key more or less in the
middle. You can, however, select a different split point:
cocci
Hold
down
.
The split point can be set anywhere between the C2
and the C6. There are two ways of changing the split
point:
1. Press and hold while setting the desired split
point with the DATA [4]/E] buttons.
The display briefly confirms the note you selected.
2. Press and hold [SPLIT] while pressing the desired key
on the keyboard.
Note: You can store this setting so that it will be used next
time you switch on the RD-150.
RD-150 - Using effects
4.8 Using effects
The RD-150 comes with three digital effects: Chorus,
Reverb, and Sympathetic Resonance. While Chorus
and Reverb are available for all Tones, Sympathetic
Resonance can only be used with piano Tones.
Adding Chorus
Chorus is an effect that gives the impression that sev-
eral instruments are being played at the same time. As
a result, the sound will be fatter and have more pres-
ence. The depth (volume) of the Chorus effect can be
set in eight steps.
Press [CHORUS] and confirm that its indicator lights.
crt KEENE THANUST OSE,
Note: The Chorus effect can be switched on and off for each
Tone separately.
Changing the depth of the Chorus
Set the depth by holding down while press-
ing DATA [3] /].
Note: The depth is preset for each Tone, but can be changed.
Adding Reverb
By using the Reverb effect, you can obtain pleasant
reverberations like those in a concert hall. The depth
of the Reverb effect can be set in eight steps.
Press [REVERB] and confirm that its indicator lights.
Changing the depth of the Reverb
Set the depth by holding down while press-
ing DATA [+] /E].
Note: The depth is preset for each Tone, but can be changed.
13