Roland RD-150 - Program Change Numbers

RD-150 Owner’s Manual—MID! functions
eee
Volume
&
Expression
filter
7.3
Program
change
numbers
Whenever you change the volume setting of the
or [UPPER] slider, the RD-150 transmits a Vol-
ume control change (CC07) on the MIDI channel
assigned to the Lower or Upper Tone. This message
can also be received for remote volume control of the
RD-150’s Tones.
Another type of (relative) volume message will be
transmitted when you use an optional EV-5 expres-
sion pedal. The corresponding control change (CC11)
can also be received.
The following procedure allows you to switch off the
transmission/reception of these messages if you don’t
need them:
1. Press [FUNCTION] ican followed PANO)
we Tock Hower
puso fino mw “iota! gi — Pane Guay
smo
Vion Reousne Favtar “Gren 8 Sun See bar ata
Pane Hass Gas Sinwes Stemes Far Stay traction
(a)
2. Use DATA [4] AZ] to select either on (transmit/
receive) or OFF (do not transmit/receive).
3. Press (FUNCTION) again to leave the Function mode.
Note: This setting can be saved along with all other settings.
See page 19.
Here are the MIDI program change numbers the
RD-150 transmits whenever you select a Tone. If the
RD-150 receives these messages, via MIDI, it will
behave in the same way as when you press the corre-
sponding Tone selection button.
Please be aware of the following for Program Change
messages:
These messages are transmitted and received on the
Lower or Upper MIDI channel. See page 20 for how to
set it.
Program Change messages are only transmitted/
received if the filter in question is set to an. See
page 21.
Piano.....
Piano 1
Pop Piano
Classic Piano
Rock Piano
Honky Tonk Voice Bass..
Stage Rhode: Orch.Strings ..
SA Rhodes. Synth Strings.
E.Piano as Synth Pad...
Clav.. Jazz Scat
Choir...
Harpsichord. Choir 1...