Roland RD-150 - Saving the Panel Settings; Restoring the Factory Defaults

6.5 Saving the panel settings
The settings that are currently in effect (everything,
including Tone selection, effect depths, Layer/Split
Tones, MIDI settings, etc.) can be saved, so that you
do not need to program them again next time you
switch on the RD-150.
Please be aware that there is one memory (a so-called
“Flash ROM”). This means that your previous settings
will be overwritten each time you save new settings.
1. Press , followed by ‘
The display now asks you for a confirmation: Sko
(Store).
2. Press DATA [4] to save your settings.
RD-f50 - Saving the panel settings
6.6 Restoring the factory defaults
To erase the contents of the RD-150’s memory (thus
recalling the factory settings):
Press and hold + while switching on the
RD-150.
The display now briefly shows the message Fck, after
which the RD-150 returns to normal operation.
19