NUMBER
1.
Turn on the power.
2.
Press the [EDIT] button while pressing both the CURSOR [ ] and
PART SELECT [LOWER] buttons to enter the Test mode.
The following screen is displayed:
fig.0info
fig.0info-1e
Turn the power off then on again, and the machine returns to normal
mode.
SAVE USER DATA &
RELOADING SAVED DATA
SAVING DATA
Transferring the RD-700’s Settings to an External MIDI Device. (Bulk Dump)
You can transfer the contents of Setups and the RD-700’s system settings to an
external MIDI device.
This operation is called ‘bulk dump.’
Use this procedure to save the data to an external MIDI device in situations
such as when you want to prevent your Setups and system settings from
corruption.
1.
Use a MIDI cable (optional) to connect the RD-700’s MIDI OUT connector
to the MIDI IN connector on an external sequencer.
2.
Press [EDIT] button to turn it on.
The Edit Menu screen appears.
fig.05-33
3.
Press CURSOR [ ] button to select ‘9.Utility.’
4.
Press CURSOR [ ] button to display the Edit screen.
fig.05-34
5.
Press CURSOR [ ] or [ ] button to select ‘Bulk Dump Temporary’
or ‘Bulk Dump SETUP.’
Parameter Value
Bulk Dump Temporary :The contents of the currently selected Setup are
transmitted.
Bulk Dump SETUP :The contents of Setups in the specified range are
transmitted.
* While the Bulk Dump is in progress, no sounds are produced even when the keys
are pressed. In addition, Rhythms and arpeggios being played are also stopped.
Bulk Dump Temporary
6.
Press CURSOR [ ] button.
A screen like the one shown below appears.
fig.05-35-1
7.
Put the external sequencer in record mode.
8.
Press [INC/YES] button to transmit the settings.
To cancel the Bulk Dump, press [DEC/NO] button.
The message “Now, Executing...” appears in the display during
transmission of the data.
9.
After the transmitting is finished, the display will indicate “COMPLETED.”
You are returned to the Edit screen.
10.
Stop the external sequencer.
Bulk Dump SETUP
11.
Press CURSOR [ ] button.
A screen like the one shown below appears.
fig.05-35-2
Parameter Value
From: Setup number for the first Setup to be transmitted.
To: Setup number for the last Setup to be transmitted.
Send System: Determines whether the system settings are to be transmitted
(YES), or not (NO).
12.
Press CURSOR [ ] / [ ] and [INC/YES]/[DEC/NO] buttons to set
the transmitted SETUPs.
13.
Press CURSOR [ ] button.
A screen like the one shown below appears.
fig.05-36-1
14.
Put the external sequencer in record mode.
Display Description
---------------------- + -----------------------------------
Product Name : Model Name
PRG Version No : Program's Version Number
PRG Build No : Program's Build Number
Booter Version : Booter's Version Number
To Next Page
Loading...
