21
Jun. 2001 RD-700
ERROR MESSAGE
Error messages
Indication : MIDI Buffer Full
Situation : Due to an inordinate volume of MIDI messages received, the RD-
700 has failed to process them properly.
Action : Reduce the amount of MIDI messages to be transmitted.
Indication : MIDI Communication Error
Situation : A problem has occurred with the MIDI cable connections.
Action : Check that MIDI cables are not broken or pulled out.
Indication : BULK DUMP: Receive Data Error
Situation : A MIDI message was received incorrectly.
Action : If the same error message is displayed repeatedly, there is a
problem with the MIDI messages that are being transmitted to the
RD-700.
Indication : BULK DUMP: Check Sum Error
Situation : There is a problem with the System Exclusive message’s Check
Sum.
Action : Check the value of the Check Sum.
Other Messages
Indication : Now, Transmitting System Exclusive.
Situation : Indicated when a Data Request message (RQ1) is received.
Action : The RD-700 outputs the requested data while this message
continues to be displayed.
Indication : Now, writing Bulk Dump Data. Keep on POWER!!
Situation : Indicated when Bulk Dump data is being received.
Action : Once received, the data is written to the RD-700’s internal
memory; be absolutely sure not to turn off the power until
“COMPLETED” appears in the display.
Indication : Unavailable while in Rec Mode
Situation : This is displayed when the [MIDI TX] button is pressed with Rec
Mode ‘ON.’
Action : When Rec Mode is ‘ON,’ you cannot change the MIDI TX settings.
To make changes to the MIDI TX settings, set Rec Mode to “OFF.”
To Next Page
Loading...
