Roland Ink System Installation
The machine and Ink System are packed in separate boxes.
Following items will be supplied by service engineers at the time of installation.
1. Product Information
12/32
*For detailed instructions on how to install the Ink System, refer to Chapter 5 of the Service Note.
Gloves (anti-slip)
Tubes inserted to ink pouch holders need to be
replaced with included Y-shaped tubes at the time of
installation. Wear gloves when replacing, and be
careful not to break them.
In case a tube breaks, use a spare tube.
A broken tube has low gas barrier capability to prevent
ink from solidifying, causing missing dots.
When using 8 colors, it is required to cut off ink tubes
at the time of installation.
Apply cleaning liquid to the cap top before performing
initial ink filling. Use water-based cleaning liquid.
Spare tubes
Scissors
to cut off ink tubes
(8 colors)
Cleaning liquid
1
2
3
4
P/N 1000002455 ASSY,TUBING 3*3080MM FP-740
Rev.1.3
To Next Page
Loading...
