8. Installation
30/32
Installation
Unpacking
Printer Installation
Ink System Installation
Take-Up Unit (TUC-3) Installation
Feed Adjuster Adjustment
Initial Ink Filling
RIP Software Installation
1
2
3
4
5
6
7
8
* Check which setting a user prefers beforehand, INWARD or OUTWARD.
Referential time: 20 min.
Referential time: 30 min.
Referential time: 25 min.
Referential time: 20 min.
Referential time: 15 min.
Referential time: 60 min.
Referential time: 15 min.
Explanations about how to operate the
printer and how to use RIP software
9
Referential time: Depends on a user’s request
Bidirectional Adjustment Referential time: 5 min.
Accumulated time: 20 min.
Accumulated time: 50 min.
Accumulated time: 75 min.
Accumulated time: 95 min.
Accumulated time: 110 min.
Accumulated time: 175 min.
Accumulated time: 190 min.
Accumulated time: 115 min.
*This is for reference only.
The amount of time required for each procedure may vary depending on the installation environment.
* The pump does not rotate for 10 minutes in order to let ink flow into sab tanks by its own gravity.
(Perform this adjustment using media a user uses.)
To Next Page
Loading...
