EasyManua.ls Logo

Roland SoundCanvas SC-88 Pro - Creating Compatible Data for the Unit; SC-88

Roland SoundCanvas SC-88 Pro
216 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Creating compatible data for the unit / SC-88
This unit has a SC-88-compatibility mode which is convenient when you wish to cre-
ate data that will be compatible with both this unit and the SC-88.
This unit provides numerous additional sounds. The additional sounds include
sounds which replace Capitals and Variation contained in the SC-88 map, and sounds
located in new Variation. Of these, the sounds which replace SC-88 map contain the
same type of sounds as in the SC-88, and are musically interchangeable with each
other. By using these sounds, you can create songs that will playback on either instru-
ment with the generally same musical result. Thus, the SC-88-compatibility mode pro-
vides an SC-88-compatible sound map. In the SC-88-compatible sound map, this unit's
high-quality sounds are arranged in the same arrangement as the SC-88 map.
The initial settings of this unit, SC-88-compatibility mode-on, and the SC-88 map
structure are as shown in the following illustration.
* The LSB is the lower byte of the Bank Select message. When the LSB is specified by a MIDI
message, the condition will be as specified by the front panel [SC-88MAP] and [SC-55MAP] but-
tons. (p.127)
When compared with SC-88, the map structure in SC-88-compatibility mode differs
only in that the SC-88-compatible map can be used, and the structure is identical in all
other respects.
In SC-88-compatibility mode, specifying a sound with a MIDI message of LSB 0 will
normally select the SC-88-compatability map, but if you press the [SC-88 MAP] button,
the SC-88 MAP will be selected. And if you press the [SC-55 MAP] button, the SC-55
MAP will be selected. With the SC-88-compatible map, sounds for this unit will be
played, but with SC-88 MAP the same sounds as the SC-88 will be played.
When creating data that must be playable on both this unit and the SC-88, you
should usually turn SC-88-compatibility mode on, and use LSB 0 to specify sounds. If
you wish to specify SC-55 MAP (or SC-88 MAP), use LSB 1 (or LSB 2) to specify
sounds.
* If you use Insertion effects, the SC-88 may not be able to produce the same playback.
Native MAP
SC-88MAP SC-88MAP
SC-55MAP
SC-88Pro Default setting
SC-88Pro, SC-88-compatibility mode=ON
LSB3
LSB2
LSB1
LSB0
SC-55MAP
SC-88MAP
SC-55MAP
SC-88(reference)
Default=Native MAP
Selected
Default=SC-88-compatible map
Selected
Default=SC-88MAP
Selected
Sounds located in new Variations
Sounds which replace Capitals and Variations contained in the SC-88 map
Chapter 5. Convenient functions
112

Table of Contents

Related product manuals