18
Recording Samples— Basic Operation
Deleting a Sample
If you are not satised with the sound you sampled, use the following procedure to delete it, and then sample the sound again.
1. Press the [DEL] button.
2. The display will indicate “dEL,” and the pads that can be deleted will blink.
Select a bank. Protected banks (p. 21) are indicated as
“
Prt” and cannot be selected.
Pads that can be deleted will blink.
3. Press the pad that you want to delete.
The selected pad will change from blinking to lit.
You can select multiple pads.
4. Press the [DEL] button to delete the sample.
NOTE
Never turn o the power before the deletion is complete. When the deletion is complete, the “dAL” indication in the
display will disappear.
To Next Page
Loading...
