Roland TR-626 - Important Information and Setup; Initialization and Memory Backup; Battery Replacement

Important
Installation
eThere may be interference if the TR-626
is played near a neon or a
light. Should this occur, change
of the TR - 626.
fluorescent
the position
eDo not play this unit where there is
excessive heat or humidity or where
it may be affected by direct sunlight
or it may become dusty.
Cleaning
eWhen it becomes dusty, wipe it clean
with a soft cloth dampened with a
neutral detergent and then wipe it once
more with a dry soft cloth.
eDo not use solvents such as paint thinner
to clean the TR- 626.
Liquid crystal display
eThe Display is best viewed from the
front of the unit.
ea should not be pushed forcibly or beaten.
Initialization
eAfter putting batteries into the TR-626
as shown below in "Battery Replacement,"
the TR-626 must be initialized. Turn
the machine off (Power Switch), then
turn it back on while holding Mode Key
and Pattern Group Key A down.
While holding
Roland i9HYTHM CDM?OSEFI TM·626
E¥¥¥¥F~: .. ;"'· > · ,~~--" ;-~=,~·~c:::: .. ~-• .. -·_~·:··'";3
MODE
PLAY
and
A D
□
1 4
POWER
OFF ON
down, turn on
1-+ITilllll
* This operation erases all the data stored
in the memory (eg. rhythm pattern and
track data). Every setting is initialized
to the values set at the factory before
shipment.
Memory Backup
Batteries are used, not only for ordinary
purposes but also to save stored data after
the unit has been turned off. However,
if the batteries are worn out or not
properly inserted, the data will be lost
after turning the power off. Even when
an AC adapter is used, batteries must kept
in the battery box.
Battery replacement
eAiways observe the following concerning
batteries.
eReplace the batteries once a year no
matter how infrequently the unit has
been used.
eAlways replace all of the batteries.
eNever include any used batteries with
a group of new batteries.
Similarly, never include a different kind
of battery in a group of otherwise
match.
eAn old battery kept in the unit may
leak battery fluid and damage the
unit. If the unit is not to be used for
long periods of time, please save the
data on a tape or the optional memory
card "M-128D", then switch the unit
off and remove the batteries. (Any
problems or damage resulting from leaked
battery fluid is not covered by the
warranty.)
eBe sure to insert batteries correct! y in
place, matching polarities correctly, positive
to positive and negative to negative.
5