Roland TR-707 - Page 24

6
EDITING
You
may
find
on listening to
your Track that
you
have
made
an
error. The
TR-707
allows you to
replace the
wrong
pattern in
a
certain bar with a
correct one,
add
or delete
patterns, groups of pat-
terns
or
complete choruses, etc.
This
editing func-
tion,
however,
requires you to
assign the
bar number
correctly.
Otherwise the
whole
editing would go
wrong.
To assign
the
bar you want:
Set the
Composer to
either Track Play
mode or
Track
Write mode.
Set the
Tempo/Measure Display
section to
Measure
display
mode
by
pushing the
Tempo/Measure Dis-
play Button
©.
•
Push the
Forward Button
©
which advances
one bar at a
time,
until
you
come to
the right
bar.
•
Push the
Back
Button ©
which backs
up
one
bar at a
time,
until you
come
to
the right bar.
•
Assign the
bar number by
holding
the Shift Key
©
down white
punching
the bar
number on
the
Main Keys
1 to 10 (press
1 and
6
for bar
number
161,
and push
the
Enter
Key.
•
Push
the Back Key
down,
while holding the
For-
ward Key
down,
and
the bars
will
be
advanced
quickly. On
the contrary,
push the
Forward Key-
down while
holding
the Back Key to
back
up
the
bars quickly.
a. Track
Editing
First, check
if the composer is in the
Track
Writing
mode, and not
running the rhythm.
d
Call the bar you
wish
to
change,
by
any
means
you
Uke
as
shown
in
"To
assign the
bar
you
want" in the
section just
before
this.
The Display will show
the number of the
assigned
bar.
(?
Press the Start Key ® to
start rhythm
pattern.
*
Skip this
procedure if
you
are editing
without
rhythm running.
,|
Select the correct
pattern.
4 Push the Enter Key
©,
which writes the correct
pattern moving onto
the next
bar.
5
Press
the
Stop
Key
©
.
24