Roland TR-707 - And

9
MEMORY
CARTRIDGE
The
Memory
Cartridge
M-64
is
an
optional extra
which will save
and load
data instantly
instead
of
using a
tape
recorder. It
acts as
additional
memory
to
enable
three times
more capacity
of Tracks
to
be
held by
the
Composer
at any one time.
When
many
tracks are
needed
during
a
live
performance,
new
tracks
can be
loaded into
the Composer during
a
break
or
intermission,
after the old ones have
been
performed.
Memory
Cartridge also
permits the
safe
storage
of
data
which might otherwise be lost
through being
accidentally
written
over.
You may
consider
the
internal memory of the com-
poser
as Bank
1
,
the Memory Cartridge as
Bank
2
and 3.
The data
in the
Cartridge can be used in
exactly the
same way as
using the data
in the
Composer's
internal memory. Just note
that
to
save
the data
in
the cartridge
onto a tape, it
should
be
loaded
from the cartridge into
the composer
then
saved
onto
a
tape, and
vice-versa.
To
operate the Memory Cartridge:
Load the cartridge
by
inserting
it into its slot
located
at
the upper left of the
composer's front
panel. Before connecting
the Memory Cartridge
to
the Composer, be sure
that it is
entered
to the Track
Playing mode,
the rhythm
is
not running and the
Protect Switch on the Cartridge
is set to
the
ON
position. The ON/OFF operation
of
the Protect
Switch should
always
be
done while in
the
Track
Play
mode,
a.
Selecting a
Bank
Enter
the Track Playing mode
with the rhythm not
running. Then,
press
the Cartridge Key
(Enter
Key)
while
holding the Shift Key down,
and the bank
moves
as
shown
below.
EZ3
Indicator
ENTER
CARTRIDGE
ACCENT
Bank Number
Indicator
dark
red
green
Bank
Composer's
memory
{Bank 1}
Memory Cartridge
IBank
2)
Memory
Cartridge
(Bank 3)
—
MEMORY
PROTECT SWITCH
35