Roland TR-707 - Measure; Main Key

c.
Loading
The ioading
procedure is
used
to take a
Track stored
on tape and load it into
the Composer.
Loading pro-
cedure is
exactly
the
same as the
Verifying except
that
you
use the Load
Key instead
of Verify. Like-
wise,
the tape
recorder
connections are the same.
Of course,
you
must
push the Play
Button on the
Pilot
tone to
avoid missing out data.
*
At any time during ioading,
pushing the Main
Key 1
can stop the loading operation.
If the
data
is
properly
saved
on
tape,
loading
will
be
done without any
problem, unless the
tape is
damaged during preservation.
If
you
want
to
load
a
numbered
fiie, then see
the following
"d. Setting
a
File
Number".
d. Setting a File
Number
A
file number (1 to 99)
can
be
allotted
to data
when
you
are saving
it.
This means that
later when
you
are loading,
you
can specify the file number
and the
Composer will choose
that
file from the
others and load it: provided
you
remember what the
file
number is.
if
load
files, whether numbered or
not, without specifying
the
file
number, then
the
Composer will load the first fiie it comes
to.
To allocate
a
file number
After pushing the
Save
Key
during step
(% in Saving
procedure on
page
31
,
choose
a
file number
(1 to
99)
from the Main Keys (1
to 10),
then push the
Enter
Key.
The assigned fiie number is shown in the Display,
To load a numbered file
O
File Number
18
1
—
Saving
After pushing the
Load
Key (Main
Key 16) in the
Loading
procedure, assign the
file number by press-
ing the relevant
Main
Key (1
to
10),
and
the Enter
Key.
If
you do
not
assign any
file number,
the
data
first found
will be
automatically
loaded.
NOTE
*
Until
the
assigned
data is
found, the
Display will
show P {Pass).
c>
c>
File Number 18
•Ready
to
Load
MEASURE
ri
(
H
i 1
1
File
Number
17
Passing
When
the assigned file
number
is found, the
Display
shows F (Found), and loading
starts.
O
File Number
18
Loading
24