Roland VC-1-DMX User Manual

2
à Attaching the plug holder
Use the plug holder to stabilize the adaptor and
prevent the plug from accidentally coming loose.
To attach the plug holder, rst remove the screw just
above the DC IN jack, align the plug holder as shown
in the illustration below and then use the screw you
just removed to ax the plug holder onto the unit.
Panel Descriptions
Front Panel
1
POWER indicator
Once you connect the AC adaptor, this unit powers
up and the POWER indicator lights up red.
2
USB port
You can congure the DMX channels by connecting this
to a computer on which dedicated software is installed.
The dedicated software for use with this unit can be
downloaded from the Roland website.
https://roland.cm/VC-1-DMX/
3
SETTING switches
Use a thin pen tip or other such tool to congure
the operation settings. For the values, refer to
“Conguring the Operation Settings” (p. 4).
4
HDMI IN connector
Connect an HDMI source device such as a computer
or BD player for video input. Video signals up to a
resolution of full HD (1080/60p) can be input. HDCP-
protected video can also be input.
5
HDMI THRU connector
Outputs the video signal input from the HDMI IN
connector as-is. Connect a device that receives HDMI
video here, such as a TV monitor.
à Attaching the rubber feet
This unit can be placed on a table or other surface,
and you can use screws or bands to ax it to a wall
or other at place for use.
When placing the unit on a table, attach the included
rubber feet in the places shown in the illustration
before use.
* When turning the unit over, handle the unit
carefully; do not drop it.
Rear Panel
1
DC IN jack
Connect the included AC adaptor here. Use only
the AC adaptor that came with this unit.
2
AUDIO IN/OUT jacks
Connect an audio device.
3
MIDI IN connector
You can connect a device here that outputs MIDI,
to control DMX lighting from that external MIDI
device.
4
DMX OUT 5-pin connector/3-pin connector
These are output connectors for DMX signals.
Use either the 5-pin or the 3-pin connector,
depending on what DMX lighting equipment
you are using.
* Pin assignment of DMX OUT connectors
1
2
3 4 5
To AC outlet
1 2 3 4
à Ground terminal
Connect this to an
external earth or
ground. This should
be connected when
necessary.
1: GND2: HOT
3: COLD
※ 入力端子の場合
2: Data–
1: GND
3: Data+
※ 出力端子の場合
1: TIP:
2: RING:
3: SLEEVE:
3 2 1
HOT
COLD
GND
1: GND2: HOT
3: COLD
※ 入力端子の場合
1: GND
2: Data–
3: Data+
※ 出力端子の場合
1: TIP:
2: RING:
3: SLEEVE:
3 2 1
HOT
COLD
GND
Plug holder

Roland VC-1-DMX Specifications

General

Brand	Roland
Model	VC-1-DMX
Category	Media Converter
Language	English