Thank you very much for purchasing the BN-20.
This document describes the procedure of "First Time Printing
and Cutting," from installation and setup of this machine to
the actual printing.
About Roland On Support
Using On Support allows you to receive your printer's ink status and error
information as an email sent to your PC and mobile phone. You can also
receive product updates and other support information from On Support.
To install On Support, download from the following URL.
http://download.rolanddg.jp/en/bn_onsupport.html
R9
-190726
Important
Leave the main power switched on at all times.
Never switch o the main power. By switching on the main power, the automatic maintenance function is carried out periodically. If the automatic maintenance is not carried out, it may
result in a machine breakdown, e.g. damage to the print heads.
Never switch off the main power or unplug the power cord during operation.
Switching o the main power or unplugging the power cord during operation may damage the print heads. Be sure to rst switch o the sub power. If the main power is accidentally
switched o, immediately turn the main and sub power back on.
Periodic use of the machine is recommended.
We recommend using the machine at least once a week. If left unused for a long period of time, the ink may settle, resulting in unstable discharge (and dot drop-out). Any dry ink will need to
be discharged.
Allow the ink to dry completely.
After output, allow the ink to dry completely. In particular, white ink and metallic silver ink must be printed with a high concentration and takes longer to dry than CMYK ink.
Lamination is strongly recommended.
Because metallic silver ink and white ink may not be as weather resistant as CMYK ink, depending on conditions, we strongly recommend laminating output of metallic silver ink.
Thank you for purchasing this product.
To ensure safe use of this product and to thoroughly familiarize yourself with its performance, be sure to read this operation manual and store it for future reference.
Unauthorized copying or transfer, in whole or in part, of this manual is prohibited.
The contents of this document and the specications of this product are subject to change without notice.
The documentation and the product have been prepared and tested as much as possible. If you nd any misprint or errors, please inform us.
Roland DG Corp. assumes no responsibility for any direct or indirect loss or damage which may occur through use of this product, regardless of any failure of this product.
Roland v Corp. assumes no responsibility for any direct or indirect loss or damage which may occur with respect to any article made using this product.
http://www.rolanddg.com/
Copyright © 2011-2019 Roland DG Corporation
Company names and product names are trademarks or
registered trademarks of their respective holders.
To Next Page
Need help?
General