Roland XP-30 - Formatting a Memory Card; Saving and Loading Data

145
Quick Reference of Procedures
Appendices
Adjusting the Keyboard Response
Sens parameter (SYSTEM/CONTROL/KEYBOARD)
Set the Keyboard to Produce a Fixed
Velocity
Vel parameter (SYSTEM/CONTROL/KEYBOARD)
■ Saving and Loading Data
* After completing these procedures, press [UTIL/CARD] to
return to the PLAY display.
Formatting a Memory Card
1. Press [UTIL/CARD].
2. Select “1: CARD” on the UTIL 2 display.
3. Select “1: FORMAT.”
4. Press [ENTER].
Saving Patch Settings
1. In Patch mode, press [UTIL/CARD].
2. Select “1: WRITE” on the UTIL 1 display.
3. Specify the writing destination.
4. Press [ENTER].
If a message of “Internal Write Protect=ON” appears, change
it to “OFF” and press [ENTER] twice.
* If you wish to hear the sound of the Patch in the selected writing
destination, press [UNDO/COMPARE]. Press it once again to
return to the previous display.
Saving Performance Settings
1. In Performance mode, press [UTIL/CARD].
2. Select “1: WRITE” on the UTIL 1 display.
3. Specify the writing destination.
4. Press [ENTER].
If a message of “Internal Write Protect=ON” appears, change
it to “OFF” and press [ENTER] twice.
Saving Rhythm Set Settings
1. In Rhythm Set mode, press [UTIL/CARD].
2. Select “1: WRITE” on the UTIL 1 display.
3. Specify the writing destination.
4. Press [ENTER].
If a message of “Internal Write Protect=ON” appears, change
it to “OFF” and press [ENTER] twice.
Saving User Memory Settings and System
Settings to Memory Card as a Unit
1. Press [UTIL/CARD].
2. Select “3: SAVE” on the UTIL 2 display.
3. Assign a file name.
4. Press [ENTER].
Deleting a File from Memory Card
1. Press [UTIL/CARD].
2. Select “1: CARD” on the UTIL 2 display.
3. Select “3: DELETE.”
4. Select the file that you wish to delete.
5. Press [ENTER].
Checking the Free Area of a Memory
Card, etc.
1. Press [UTIL/CARD].
2. Select “1: CARD” on the UTIL 2 display.
3. Select “4: INFO.”
■ Controlling External MIDI
Devices
Changing the Transmit Channel for
Patch Mode
Tx-Ch parameter (SYSTEM/MIDI/PATCH MIDI)
Changing the Transmit Channel for
Performance Mode (for each Part)
Channel parameter (PERFORM/MIDI/MIDI)
* Keyboard and controller movements (MIDI messages) from the
controller section are transmitted differently depending on
whether a single-type Performance or a layer-type Performance
is selected. If a single-type Performance is selected, MIDI
messages will be transmitted on the MIDI channel of the Part
that is being played by the keyboard. If a layer-type Performance
is selected, MIDI messages will be transmitted on the MIDI
channel of the Parts whose Tx parameter (PERFORM/MIDI/
MIDI) is turned ON.