Roland XPS-60 - Copying the Contents of a Step to Another Step (COPY STEP); Copying the Contents of One Track to Another (COPY TRACK); Initializing All Tracks (INITIALIZE)

39
Playing back/recording with the step sequencer
Copying the contents of a step to another step
(COPY STEP)
You can copy the data contained in a step to a dierent step. This
copies the step at the specied step number to another step.
1. On the SEQUENCER UTILITY screen, select “COPY
STEP” and press the [ENTER] button.
The COPY STEP screen appears.
2. Select “(copy source step number) Ë (copy
destination step number)” and press the [ENTER]
button.
If you decide to cancel, press the [EXIT] button.
The screen indicates “Completed” when the copy is completed.
Copying the contents of one track to another
(COPY TRACK)
You can copy the data contained in the step sequencer from one
track to another. This copies all steps at the specied track number to
another track.
1. On the SEQUENCER UTILITY screen, select “COPY
TRACK” and press the [ENTER] button.
The COPY TRACK screen appears.
2. Select “(source track number) Ë (destination track
number)” and press the [ENTER] button.
If you decide to cancel, press the [EXIT] button.
The screen indicates “Completed” when the copy is completed.
Initializing all tracks (INITIALIZE)
Here’s how to erase the notes and control change messages from
all tracks. This also initializes step sequencer settings such as Step
Length and Scale for all tracks.
MEMO
You can also initialize by pressing the [ERASE] button.
1. On the SEQUENCER UTILITY screen, select
“INITIALIZE” and press the [ENTER] button.
A conrmation message appears.
If you decide to cancel, press the [EXIT] button.
2. Move the cursor to “OK” and press the [ENTER]
button.
The sequencer is initialized.